Skip to content

29 CFR 1903.19(i) · movable equipment · not legal advice

OSHA movable equipment tagging after a citation (29 CFR 1903.19(i))

Most employers know they must post a Federal OSHA citation on a wall or bulletin board. Fewer notice the separate rule for movable equipment — a tool, machine, or device that can be moved within a worksite or sent to the next job. This guide explains that tagging rule in 29 CFR 1903.19(i), using the official text.

When the tagging rule applies

1903.19(i)(1) applies to serious, repeat, and willful violations involving movable equipment. It does not, by its own terms, apply to other-than-serious items. If your citation classifies an item as other-than-serious, this tagging paragraph is not the rule that covers it. The ordinary citation-posting rule in 29 CFR 1903.16 can still apply. See citation posting requirements.

"Movable equipment" is defined in 1903.19(b)(5) as a hand-held or non-hand-held machine or device, powered or unpowered, that is used to do work and is moved within or between worksites. That definition is broad. It can include a hand tool, a portable saw, a forklift, a compressor, or similar equipment that does not stay in one place.

What you must attach, and where

The employer must attach a warning tag or a copy of the citation to the operating controls or to the cited component of equipment that is moved within the worksite or between worksites (1903.19(i)(1)).

The note to 1903.19(i)(1) is important: attaching a copy of the citation to the equipment is deemed by OSHA to meet the tagging requirement of 1903.19(i)(1) and the posting requirement of 1903.16. In other words, for that piece of equipment, a securely attached, unaltered copy of the citation can satisfy both duties. A homemade tag is not required if you attach a copy of the citation. If you use a tag instead, it must still do the job described below.

What a warning tag must say

If you use a warning tag rather than (or in addition to) a copy of the citation, 1903.19(i)(2) requires that the tag:

  • properly warn employees about the nature of the violation involving the equipment; and
  • identify the location of the citation issued.

Appendix C to 1903.19 provides a nonmandatory sample warning tag. You may use that sample, or another tag that includes the required information. The tag or citation copy must not be altered, defaced, or covered by other material (1903.19(i)(5)).

For construction work, a tag designed and used in accordance with 29 CFR 1926.20(b)(3) and 29 CFR 1926.200(h) is deemed to meet this section when the information required by 1903.19(i)(2) is included on the tag (1903.19(i)(4)).

When to attach it

If the violation has not already been abated, a warning tag or copy of the citation must be attached (1903.19(i)(3)):

  • for hand-held equipment, immediately after the employer receives the citation; or
  • for non-hand-held equipment, prior to moving the equipment within or between worksites.

That split matters on a construction or service job where a machine might be loaded on a truck the same afternoon the citation arrives. Non-hand-held equipment should be tagged before it is moved. Hand-held equipment should be tagged as soon as the citation is in hand, if the cited condition is still present.

If the violation has already been abated, 1903.19(i)(3) is written around the case where it has not. Abatement verification, including certification and any required documents, is still governed by the rest of 1903.19.

When the tag may come off

The employer must assure that the tag or copy of the citation remains attached until one of the following is true (1903.19(i)(6)):

  • the violation has been abated and all abatement verification documents required by the regulation have been submitted to the Agency;
  • the cited equipment has been permanently removed from service or is no longer within the employer's control; or
  • the Review Commission issues a final order vacating the citation.

Correcting the hazard is not, by itself, enough to remove the tag if the required certification or documentation has not yet been submitted. Taking a machine out of service permanently, or losing control of it (for example, returning a rental that is no longer yours), is a separate listed condition. A vacated citation is the third.

How this fits with wall posting and certification

Tagging movable equipment does not replace the rest of your citation response:

  • The citation still has to be posted under 1903.16, except that a citation copy on the equipment is deemed to meet 1903.16 for that equipment, as noted above. Other cited conditions that are not on movable equipment still need the ordinary posting.
  • Abatement still has to be completed by each item's abatement date, then certified within 10 calendar days, with documents when 1903.19(d) requires them. See OSHA abatement certification and the sample certification letter.
  • When you submit abatement documents, 1903.19(g) still requires employee notification by posting a copy or summary.

OSHA 3000 also notes the movable-equipment tagging option in its posting discussion, pointing readers to 1903.19(i).

A short example, without treating it as your case

Suppose a citation includes a serious item for a portable, non-hand-held compressor used at more than one jobsite, and the cited condition has not yet been corrected. Before that compressor is moved to the next site, the employer attaches a copy of the citation, or a warning tag that describes the hazard and says where the citation is posted, to the operating controls or the cited component. The copy or tag stays there until the condition is corrected and the required abatement verification documents have been sent to the Area Office, unless the equipment is permanently removed from service or the citation is vacated. This is only an illustration of how 1903.19(i) is written. Your citation controls.

Official sources

If a State Plan issued your citation

This page follows the Federal OSHA rules (29 CFR 1903.16 and 1903.19).29 State Plans run their own OSHA programs (22 of them cover private employers) and can set their own posting, tagging, and certification rules and deadlines. If a State Plan issued your citation, check that plan's rules instead: osha.gov/stateplans.
State Plans covering private employers

Alaska Occupational Safety and Health (AKOSH); Arizona Division of Occupational Safety and Health (ADOSH); California Division of Occupational Safety and Health (Cal/OSHA); Hawaii Occupational Safety and Health (HIOSH); Indiana Occupational Safety and Health Administration (IOSHA); Iowa OSHA; Kentucky Occupational Safety and Health; Maryland Occupational Safety and Health (MOSH); Michigan Occupational Safety and Health Administration (MIOSHA); Minnesota OSHA; Nevada OSHA; New Mexico Occupational Health and Safety Bureau; North Carolina Department of Labor — OSH Division; Oregon OSHA; Puerto Rico Occupational Safety and Health Administration (PR OSHA); South Carolina OSHA; Tennessee Occupational Safety and Health Administration (TOSHA); Utah Occupational Safety and Health (UOSH); Vermont Occupational Safety and Health Administration (VOSHA); Virginia Occupational Safety and Health (VOSH); Washington Department of Labor & Industries — DOSH; Wyoming OSHA.

Look up your inspection's free preview

If you have a Federal OSHA inspection number, you can look up the public record and see a free preview of how the cited items, dates, and a draft documentation packet would be organized. The inspection number is printed near the top of your Citation and Notification of Penalty. No account or credit card is required to preview. Check every imported fact against your own citation. CiteClock organizes the record; it does not certify compliance or file anything for you. Activating the case is a one-time purchase. Self-Serve is $49 per case for one user to organize evidence and assemble exports. COMMAND is $149 per case and adds up to 5 people on the case, task assignments and worker evidence requests. Access continues while CiteClock operates, subject to the Terms of Service. Sales tax or VAT may be added at checkout where applicable. An active Self-Serve case can upgrade to COMMAND for $100; the upgrade keeps that case's existing access terms. Sign in to buy.

Look up your inspection number — free drafted packet preview Abatement deadline calculator See a sample packet

This is a plain-English summary of Federal OSHA rules, written from the official text. It is not legal advice, and it is not a substitute for your citation, a settlement agreement, or the official regulations. Your citation and the official text govern. CiteClock is independent software. It is not affiliated with OSHA, the U.S. Department of Labor, or any government agency, and it does not provide legal advice. CiteClock does not file, sign or send anything to OSHA for you. If your case involves a contest, a settlement negotiation, a serious injury, or a State Plan citation, talk to an attorney or a qualified safety professional, and follow the agency that issued your citation. Independent software. Not affiliated with OSHA. Not legal advice.